Welcome! | Borowski Racing |Third Shift Studios |Sponsored by Taylor Wires!!! |Sponsored by PowerMaster!!! | Sponsored by FrozenBoost!! |Sponsored by US Speedo! |
fast4popper
  • fast4popper
  • 100% (Exalted)
  • Advanced Member Topic Starter
11 years ago
i have been poking around again on a few sites and i have always wondered, why do people always brag about how high the RPMs are on their stall convertor? I mean, at 3600+ is it really streetable? you are guZZling gas like its still 1$ a gallon!

Ok, off my rant now, and LOVING the fact that i only want a 2600 rpm stall... I had a 3600 and HATED it!!

have a great day!
Sponsor
Site Sponsor.. FROZEN BOOST http://frozenboost.com/ Site Sponsor.. US SPEEDO! http://www.usspeedo.com/ Check them out for your custom Cluster needs! Site Sponsor.. Wegner Motorsports http://wegnerautomotive.com/ They make bad ass valve cover and incredible engines for these trucks! Site Sponsor .. PowerMaster http://powermastermotorsports.com/
Bonj87
  • Bonj87
  • 100% (Exalted)
  • Administration
11 years ago
they're not worried about streetable.. they want to brag that thier 60' times are so low, and thier 1/4 mile times are so slow.
for those who like to street thier trucks quite often, lower stall makes it better.. mine was a 2800, now its probably a 3100
http://www.taylorvertex.com 
http://www.frozenboost.com 
Sponsored by US SPEEDO!
http://www.usspeedo.com/ 
fast4popper
  • fast4popper
  • 100% (Exalted)
  • Advanced Member Topic Starter
11 years ago
i just think its stupid. are these the same people that take every ounce of weight off the truck just to get a time slip? down to 16" wheels, no tail gate, and sh!t, with only 4 bolts, why not take the bed off too?

dumb!

run what ya brung, on the street, in the real world!

ok i am off my rant now
Users browsing this topic