OK OPERATION STEERING WHEEL....
to get the buttons out or the "boxes" the house the buttons you will need a small screw driver to pry them out . once you get them pried far enough grab them with your fingers and pull on it till you see the clip behind them. use a smaller screw driver to unclip them .the bottom buttons will be a PITA to get out. once out use that small crew driver to open the boxes. once open this is what it will look like....
arrows represent positive side on this one...
arrows represent
negative side on this one THIS PIC WAS TAKEN B4 I SWAP THE LED/RESISTOR AROUND...
arrows represent positive side on this one...
arrows represent positive side on this one...
ok after you get them all together with your LEDS AND RESISTORS you are ready to plug back in, tops should go in fine you might need some needle nose pliers to grabb the wire to connect it back to the box for the top. and for the bottom you are going to have to pull the airbag off. i didnt unplug the battery or do any of that funny $hit. go about it how you want to thou, im not responcible for your actions :uhoh: .
to pull the airbag off your going to need a small screw driver that will fit in the little holes on the side / back of the steering wheel . as you push the screw driver in them and put pressure on it you will feel something compress about a 1/4 inch, while it is compressed pull on the top of your steering wheel airbag , that side will pop off and repeat for the other side.once off this is what you will see...
the small wire i em holding is the wire for the bottom right button box. you will have to re route this to get enough wire to plug the box back in. it should look like this after the reroute...
i used a screw driver and some needle nose to reroute it. now b4 you button everything up make sure you test your lights to make sure everythng is working alright. then just push the AIRBAG back on and your done.
hevy: NOTE I DID NOT DISCONNECT THE AIRBAG.
